| |||||||||||||
The Manual Digital Enamel Rater is used to check the interior lacquer coating on cans and ends. The current flow is measured in mA to determine lacquer permeability. The Manual Digital Enamel Rater is quickly and easily configured for: test voltage (4V, 6.3V or 10V); measurement range (0-200mA or 0-2000mA); test time (from 1 to 99 seconds); and test polarity.
A 90 Ohm calibrated test resistor may be provided for calibration, as well as enamel testing fixtures for 3-Piece Cans, 2-Piece Cans, Aerosol Cans, Can Ends, Side Stripes, Bottle Caps, and even Tubes.
For cans there are three different mount fixtures. All connect to the contact control. For three piece cans there are two different sizes of can testers and for the beverage cans one can tester available.
For can ends an attachment is required, corresponding to the diameter. Attachments from 40 to 230 mm in diameter are available. All attachments secure the end in place with a vacuum (vacuum pump or venturi required) and enable problem-free measurements.
Contact control, filling control, measure duration, current limits, printout handling of one intermediate reading (two measurement duration)
The results are shown on the display and may be saved or printed
out via serial printer. Results are also available for data
transfer either directly into a plant-wide data collection system,
or for data transfer directly into Visionary QC or other data
acquisition software.
(Fixtures for Can and End Enamel Testing required.)

Can your Peel Seals take the pressure? Log In Now for More Information The Peel Seal Burst Tester tests the burst pressure of loose Peel Seal Ends. ...
Test Your PET Bottles Without Testing Your Budget Log In Now for More Information This easy to use top load tester measures the top load resistance of ...
Pressure your Cans to Maintain the Highest Quality. Log In Now for More Information The Panel Implosion Tester (Panel Tester) can be used to measure ...
Log In Now for More Information Accessory tester for crowns. For use with ENR-16, 16-Station Enamel Rater for porosity testing. Crowns may be tested ...
16 Station Enamel Rater Accessory Log In Now for More Information Accessory tester for enamel rating twist-off caps. For use with ENR-16, 16-Station ...
Axial Load and Panel Strength in one compact unit! Log In Now for More Information The unit is a composite device for axial load and implosion ...